Filter
Top Products
2. PLOTTER OPERATION
2-60
Alarm messages
The table below shows the plotter alarm messages and their meanings.
Plotter alarm messages and their meanings
Message Meaning
ARRIVED AT XXX WAYPOINT!
(XXX = waypoint name)
Arrival alarm violated.
ENTERED INTO AVOIDANCE
AREA!
Proximity alarm violated.
EXCEEDED ANCHOR WATCH
LIMIT!
Anchor watch alarm violated.
EXCEEDED XTE LIMIT! XTE alarm violated.
SPEED ALARM! Speed alarm violated.
TEMPERATURE ALARM! Water temperature alarm
violated.
TRIP ALARM! MILEAGE
EXCEEDED
Trip alarm violated.
2.12 Resetting Trip Distance
Trip distance is shown on the navigation data display. You can reset the trip
distance to zero as follows:
1. Press the [MENU] key.
2. Press the SYSTEM CONFIGURATION and GENERAL SETUP soft keys in
that order to show the GENERAL SETUP menu.
▲
GENERAL
SETUP1
EDIT
NEXT
PAGE
RETURN
KEY BEEP
ON
LANGUAGE
ENGLISH
RANGE UNIT
nm, kt
TEMPERATURE UNIT
°
F
DEPTH UNIT
ft
TEMPERATURE SOURCE
NMEA
DEPTH SOURCE
NMEA
RESET TRIP LOG
NO
General setup menu, page 1
3. Use the cursor pad to select RESET TRIP LOG, then press the EDIT soft key.
4. Use the cursor pad to select YES.
5. Press the ENTER soft key.
6. Press the [MENU] key to close the menu.