Filter
Top Products
10. INSTALLATION
10-16
Setting DATA 4 to "COM." (general data)
Waypoint data can be received from a personal computer, through the DATA 4
port. Note that the data transmitting operation should be done after receiving
data using DATA 4 port. For details, see page 1-6.
1) Press MENU ESC, 9 and 5.
2) Press
to select Level.
3) Press
or to select level of personal computer; RS232C or RS422.
4) Press the CU/NU ENT key.
5) Press
or to select Com.
6) Press
to select To Next Page. The DATA 4 I/O SETUP <Com.> menu
appears.
Loading erases current data
Are you sure to load?
ENT: Yes MENU: No
I/O SETUP <Com.> menu
7) Press
to select Baud Rate.
8) Press
or to select baud rate; 4800bps, 9600bps, or 19200bps.
9) Press the CU/NU ENT key.
10) Press
to select WPT/RTE.
11) Press
to select Command. Stop, on the same line as Command, appears
in reverse video.
12) Press
to select Start. The message shown in below appears.
Now loading
WPT/RTE data !
MENU: Stop
13) Press the CU/NU ENT key. The message shown in below appears while data
is being loaded.
Are you sure to stop ?
ENT: Yes MENU: No
14) Output data from the computer. When data is loaded, the cursor shifts to
Stop.
15) Press the ESC key.