Filter
Top Products
4. NAVIGATION PLANNING
4-7
4.6 Replacing Route
Waypoints
Route waypoints are mutually replaced when
the navigators are sharing data.
1) Press WPT RTE and 5 to display the
route list.
2) Press
or to select route.
3) Press
to display route editing screen.
4) On the route editing screen, place the
cursor on waypoint number to replace.
5) Enter new waypoint number.
6) Press the NU/CU ENT key. The message
shown in Figure 4-16 appears.
This waypoint already exists
Are you sure to change ?
ENT: Yes
MENU: No
Figure 4-16
7) Press the NU/CU ENT key.
8) Press the MENU ESC key twice.
4.7 Erasing Routes
Routes are mutually erased when the
navigators are sharing data.
1) Press WPT RTE and 5 to display the
route list.
2) Press
or
to select route to erase.
3) Press the CLEAR key. The display
shown in Figure 4-17 appears if the route
is in use.
1st line
Are you sure to erase ?
ENT: Yes
This route is in use
MENU: No
Figure 4-17
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.