Filter
Top Products
8. MENU SETTINGS
8-3
GPS position smoothing
1) Press MENU ESC, 9 and 6.
2) Press
or to select Posn.
3) Enter smoothing factor in three digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
GPS speed smoothing
1) Press MENU ESC, 9 and 6.
2) Press
or to select Spd.
3) Enter smoothing factor in three digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Speed averaging
1) Press MENU ESC, 9 and 6.
2) Press
to select Speed Average.
3) Enter smoothing factor in two digits
(0000-9999).
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
RAIM function
1) Press MENU ESC, 9 and 6.
2) Press
to select RAIM function on
page 2/2.
To Previous Page
Posn Offset 0.000’ N 0.000’ E
Time Diff. +00:00
Posn 38 00.000’ N 123 00.000’ W
GPS SETUP 2/2
MENU : Escape
: Select
ENT : Enter
: +/
RAIM Function OFF
Geodetic Datum WGS84 NAD27 OTHER
(Cannot be changed) (001)
RAIM Accuracy 100 m
ON
Figure 8-2 GPS SETUP menu, page 2/2
3) Press
or
to turn RAIM function ON
or OFF as appropriate.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
RAIM accuracy
1) Press MENU ESC, 9 and 6.
2) Press
or
to select RAIM accuracy
on page 2/2.
3) Key in the range for which you want to
know RAIM accuracy (1 to 999 m).
Note: Unit is meter only.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Geodetic datum
1) Press MENU ESC, 9 and 6.
2) Press
or
to select Geodetic
Datum on page 2/2.
3) Press
or
to select geodetic datum
to use. For geodetic datum other than
WGS-84 or NAD-27, select OTHER and
key in chart number (001-173) referring
to the geodetic chart list in the Appendix.
4) Press the NU/CU ENT key.
5) Press the MENU ESC key.
Position offset
If you do not know the type of chart you are
using, GPS position may be wrong. Note the
difference in position when moored to a pier
and enter it on the GPS SETUP menu, to get
correct position.
1) Press MENU ESC, 9 and 6.
2) Press
or
to select Posn Offset on
page 2/2.
3) If necessary press
to switch from
north latitude to south latitude or vice
versa.
4) Key in latitude correction.
5) If necessary press
to switch from
east longitude to west longitude or vice
versa.
6) Key in longitude correction.
7) Press the NU/CU ENT key.
8) Press the MENU ESC key.
The
L
L
icon appears when L/L offset is
applied.