Filter
Top Products
vii
Usage Precautions
• The Motion Sensor MS-100 compensates for ship’s pitching and rolling. However, it does
not compensate for load unbalance.
• If the equipment will not be used for a long time, shut off the power to it at the mains
switchboard, to prevent battery discharge.
• If the soundome is to be operated while the ship is dry-docked, set the transmitter output
power to “minimum” (on the COM1 menu). Damage to the train-tilt section may result if it
is operated with maximum transmitter power while the ship is dry-docked.
• When the ship is dry-docked check for signs of corrosion on the soundome. Find the
reason for the corrosion and attach a zinc plate to the hull unit as an anticorrosion
measure if necessary.
Notice
• No part of this manual may be copied or reproduced without written permission.
• If this manual is lost or worn, contact your dealer about replacement.
• The contents of this manual and equipment specifications are subject to change without
notice.
• The example screens (or illustrations) shown in this manual may not match the screens
you see on your display. The screen you see depends on your system configuration and
equipment settings.
• This manual is intended for use by native speakers of English.
• FURUNO will assume no responsibility for the damage caused by improper use or
modification of the equipment or claims of loss of profit by a third party.