Filter
Top Products
©2011 Edelbrock LLC
Part #1596, 1597, 1598 & 1599
Brochure #63-1598
Rev. 2/11 - AJ/mc
Edelbrock E-Force Supercharger System for
the 2010 Camaro SS
Installation Instructions
Page 8
11. Disconnect the Mass Airflow Sensor connector.
12. Use a flat head screwdriver to loosen the worm clamp
holding the inlet tube to the air box lid then remove the air
box lid by pushing the lock tabs back.
13. Remove the oil fill cap and remove the plastic engine
cover. Reinstall the oil fill cap.
14. Disconnect passenger side PCV tube from the valve
cover then use a flat head screwdriver to loosen the worm
clamp retaining the air intake tube to the throttle body.
Remove and discard the air intake tube and PCV hose.
15. Use a 15mm socket and a breaker bar to loosen the
tensioner and remove the serpentine belt.
16. Disconnect the Electronic Throttle Control connector
on the passenger side of the throttle body.
17. Use a 10mm socket to remove the four bolts retaining
the throttle body and set it aside.
18. Push down the white tab on the front EVAP hose
fittings and disconnect them from the manifold and the
EVAP solenoid.
19. Disconnect the Manifold Air Pressure sensor and
EVAP solenoid electrical connectors.
20. Use a 3/8” Fuel Line Removal Tool to disconnect the
fuel line from the fuel rails and from the passenger side
fender fitting. Use a shop rag to absorb any excess fuel.
21. Use a 10mm socket to remove the nut holding down
the fuel line clamp then remove the fuel line and clamp.