Filter
Top Products
©2011 Edelbrock LLC
Part #1596, 1597, 1598 & 1599
Brochure #63-1598
Rev. 2/11 - AJ/mc
Edelbrock E-Force Supercharger System for
the 2010 Camaro SS
Installation Instructions
Page 2
Due to the complexity of the Edelbrock E-Force Supercharging system, it is recommended that this system only be
installed by a qualified professional with access to a service lift, pneumatic tools, and a strong familiarity with
automotive service procedures. To qualify for the optional warranty, it is necessary to have this system installed by a
certified ASE technician, GM dealership, or Edelbrock approved installer. Failure to have this system installed by a
properly certified service center may result in voiding of the optional warranty offered with this sytem. Please contact
the Edelbrock Technical Support department if you have any questions regarding how this sytem and/or your installer of
choice will affect any warranty coverage for which your vehicle may qualify.
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
result in poor performance and engine or vehicle damage.
Any equipment that directly modifies the fuel mixture or ignition timing of the engine can cause severe engine damage
if used in conjunction with the Edelbrock E-Force Supercharger System. This includes, but is not limited to: ignition
boxes, air/fuel controllers, OBDII programmers, and any other device that modifies signals to and/or from the ECU.
Aftermarket bolt-on equipment such as underdrive pulleys or air intake kits will also conflict with the operation of the
supercharger and must be removed prior to installation. Use of any of these products with the E-Force Supercharger
could result in severe engine damage.
Any previously installed aftermarket tuning equipment must be removed and the vehicle returned to an as
stock condition before installing the supercharger.
91 octane or higher gasoline is required at all times. If your vehicle has been filled with anything less, it
must be run until dry and refilled with 91 or higher octane gasoline twice prior to installation.
Inspect all components for damage that may have occured in transit before beginning installation. If any
parts are missing or damaged, contact Edelbrock Technical Support, not your parts distributor.
Edelbrock periodically releases improved versions of the calibration file found on the supplied handheld
programmer. Check the website to ensure you have the latest version, as described in step #165.