A SERVICE OF

logo

Q1860-90918 Chapter 3 Printer operation 59
Service mode
Service mode should be used only by authorized service personnel. While in service mode, you
can:
Verify and set the page count, maintenance count (pages since last maintenance), and serial
number. These are shown on the configuration page.
Set the cold reset default. (This sets the factory default paper size to either Letter or A4).
Turn the diagnostic functions on or off (for developers only).
Clear the event log.
Set the page interval at which the next PERFORM PRINTER MAINTENANCE message appears
on the control panel.
To use service mode
1 Hold down [S
ELECT] and [CANCEL JOB] while turning on the printer. (If the control panel reads
INITIALIZING, you released the keys too soon.)
2 After the three LEDs under the display are lit, press the right side of the [M
ENU] key, and then
press [S
ELECT]. The SERVICE MODE message appears. To exit the service mode press [GO].
Service menu
Figure 7. Service menu
www.GovTechMedia.com