A SERVICE OF

logo

136 Removing and replacing parts Q1860-90918
Pickup gear assembly
1 Remove the top cover (see page 115), the left side cover (page 123), and the paper-handling
PCA (page 131).
2 Release the small spring (callout 1) on the gear.
3 Remove the four self-tapping screws (callout 2) from the gear assembly.
4 Remove the pickup gear assembly from the chassis.
CAUTION Be careful not to damage the tray-size sensor springs when removing or replacing the pickup
gear assembly.
Figure 65. Pickup gear assembly removal (left side of printer)
Note Before replacing the pickup gear assembly, route the cables through the wire clip (callout 3) that
is on the back of the left corner cover. Reattach the spring from the Tray 2 shaft gear to the shaft
of the pickup assembly gear.
2
2
2
2
1
3
www.GovTechMedia.com