Filter
Top Products
3 - 33
INSP
ADJ
FRONT FORK INSPECTION
3. Adjust:
• Drive chain slack
Drive chain slack adjustment steps:
• Loosen the axle nut 1 and locknuts 2.
• Adjust chain slack by turning the adjusters
3.
To tighten
→
Turn adjuster
3
counter-
clockwise.
To loosen
→
Turn adjuster
3
clockwise
and push wheel forward.
• Turn each adjuster exactly the same
amount to maintain correct axle alignment.
(There are marks a on each side of chain
puller alignment.)
N
OTE:
Turn the adjuster so that the chain is in line
with the sprocket, as viewed from the rear.
CAUTION:
Too small chain slack will overload the
engine and other vital parts; keep the
slack within the specified limits.
• Tighten the axle nut while pushing down
the drive chain.
T
R
.
.
Axle nut:
125 Nm (12.5 m • kg, 90 ft • lb)
• Tighten the locknuts.
T
R
.
.
Locknut:
16 Nm (1.6 m • kg, 11 ft • lb)
EC36C000
FRONT FORK INSPECTION
1. Inspect:
• Front fork smooth action
Operate the front brake and stroke the
front fork.
Unsmooth action/oil leakage → Repair or
replace.