Filter
Top Products
4 - 93
ENG
CRANKCASE AND CRANKSHAFT
5. Install:
• Dowel pin 1
• O-ring 2
• Crankcase (right)
To crankcase (left).
N
OTE:
• Fit the crankcase (right) onto the crankcase
(left). Tap lightly on the case with soft ham-
mer.
• When installing the crankcase, the connect-
ing rod should be positioned at TDC (top
dead center).
New
6. Tighten:
• Hose guide 1
• Clutch cable holder 2
• Bolt (crankcase)
N
OTE:
Tighten the crankcase tightening bolts in
stage, using a crisscross pattern.
7. Install:
• Oil delivery pipe 2
• O-ring
• Bolt (oil delivery pipe 2)
8. Install:
• Timing chain
• Timing chain guide (rear)
• Bolt (timing chain guide)
9. Remove:
• Sealant
Forced out on the cylinder mating sur-
face.
10. Apply:
• Engine oil
To the crank pin, bearing and oil delivery
hole.
11. Check:
• Crankshaft and transmission operation.
Unsmooth operation → Repair.
T
R
.
.
12 Nm (1.2 m · kg, 8.7 ft · lb)
New
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)