Filter
Top Products
3 - 43
INSP
ADJ
STEERING HEAD INSPECTION AND ADJUSTMENT
• Tighten the ring nut 3 using ring nut
wrench 4.
N
OTE:
• Apply the lithium soap base grease on the
thread of the steering shaft.
• Set the torque wrench to the ring nut
wrench so that they form a right angle.
Ring nut wrench:
YU-33975/90890-01403
T
R
.
.
Ring nut (initial tightening):
38 Nm (3.8 m • kg, 27 ft • lb)
• Loosen the ring nut one turn.
• Retighten the ring nut using the ring nut
wrench.
WARNING
Avoid over-tightening.
T
R
.
.
Ring nut (final tightening):
7 Nm (0.7 m • kg, 5.1 ft • lb)
• Check the steering shaft by turning it lock
to lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
• Install the plain washer 5, handle crown
6, plain washer 7, steering shaft nut 8,
steering shaft cap 9, handlebar 0, han-
dlebar holder A and number plate B.
N
OTE:
• The upper handlebar holder should be
installed with the punched mark a for-
ward.
• Install the handlebar so that the marks b
are in place on both sides.
• Insert the end of fuel breather hose C into
the hole in the steering shaft cap.
CAUTION:
First tighten the bolts on the front side of
the handlebar holder, and then tighten
the bolts on the rear side.