Filter
Top Products
ENGINE AND PERIPHERALS
Overhauling the engine
10
10-87
Before fitting the cylinder liners-pistons-con rods
assemblies in the cylinder blocks, don't forget to
place an O-ring on each cylinder liner, making sure
that it is not twisted, as well as a shaft seal..
Fit the cylinder liners-pistons-con rods assemblies
in the cylinder block, making sure they are in the right
positions.
The cylinder liner flat surfaces need to be parallel.
The piston combustion cut-out should be pointing
towards the relay shaft side.
If the con rod is pierced, point the oil jet towards the
end opposite the relay shaft.
Fit the cylinder liner retaining flange Mot. 521-01 and
tighten the bolts and mounting nuts to 5 daNm.
Fit the con rods onto the oiled big end journals of the
crankshaft.
16558R