Filter
Top Products
ENGINE AND PERIPHERALS
Overhauling the engine
10
10-113
Refit:
– the timing cover,
– the high pressure pipes on the injection pump using Mot. 1383,
– the inlet and exhaust manifolds, by tightening the nuts to a torque of
2.8 daNm,
– the lifting bracket at the flywheel end and the fuel pipe support plate,
– the multifunction support, tightening the nuts and bolts to a torque of
4.3 daNm,
– the alternator,
– the air conditioning compressor (if fitted),
– the power assisted steering pump,
– the crankshaft accessories pulley by tightening the bolt to a torque of
2 daNm, then angle tightening to 115˚ ± 15˚.