Renault J8S Automobile Parts User Manual


 
ENGINE AND PERIPHERALS
Overhauling the engine
10
10-112
If this is not the case, correct the setting.
IMPORTANT: the following operations must be carried out in this order.
Remove TDC setting rod Mot. 861 or Mot. 1054.
Turn the injection pump to obtain the desired setting value (see above table).
Tighten the injection pump mounting bolts.
Turn the engine over twice and pin the engine again.
Check the corresponding setting value again.
Fit sprocket locking tool Mot. 854 or use tool Mot. 799-01, then tighten the injector pump pulley to a torque of
5 daNm.
Remove rod Mot. 861 or Mot. 1054.
Turn the engine over twice and check the injection pump timing again.
MANUFACTURER TYPE
Top dead centre setting
(rod in the crankshaft)
Piston lift (mm) Pin lift (mm)
BOSCH
VE.. R484
VE.. R484-1
0.75 -
ROTO DIESEL
DPC R8443 B142B
DPC R8443 B143B
-
dimension "X" on
pump
ROTO DIESEL
DPC R8443 A400 A to
A409 A (A)
DPC R8443 A401 B to
A409 B (A)
DPC R8443 B402 B to
B409 B (B)
DPC R8443 B403 C
to B409 C (B)
-
1.80 (A)
dimension "x" on
pump (B)