Filter
Top Products
User's manual MobileNavigator | 5
- 12 - Installing the hardware
2.2.2 Mounting and connecting the GPS receiver
Caution: The mounted GPS receiver must not impede the
driver’s attention on traffic.
Connecting the GPS
receiver...
1. Place the GPS receiver horizontally under the windscreen, as
far forwards as possible.
Note: The reception of GPS-signals may be obstructed by
windscreen heating wires, by a windscreen aerial, or when the
windscreen is moralised. In this case, you might use an
external vehicle antenna, which may be obtained from our
support team, from our online-shop, or from your specialised
dealer.
2. Plug the connection cable of the GPS receiver to the
respective socket of the adapter, which connects the Pocket
PC to the power supply.
3. Plug the jack of the adapter into the socket of the cigarette
lighter.
4. Turn the GPS receiver on.
2.2.3 Installing the Bluetooth module
Bluetooth module If you have purchased the Bluetooth module together with your
GPS-receiver, it was inserted and has been set up during the
installation procedure.
In case you have purchased it as a supplement proceed as
described in "Bluetooth module", page 121.