Filter
Top Products
User's manual MobileNavigator | 5
- 122 - Annex B: Problem solutions
Manual settings 1. Tap Manual settings when automatic detection is not
successful. Set the following values:
2. Tap the Type of receiver field and indicate the type of your
GPS receiver.
You have… then…
the expandable NAVIGON GPS
receiver,
select Navigon Modular.
a non-expandable NAVIGON GPS
receiver with TMC,
select Navigon with
TMC.
a non-expandable NAVIGON GPS
receiver without TMC,
select Navigon without
TMC.
a GPS receiver of another brand,
select Other receiver.
an integrated GPS receiver and
an external TMC receiver
select Integrated GPS /
external TMC.
3. Tap the COM port field and indicate the COM-port.
Note: If you have established a wire connection, it is
normally COM-Port 1.
Please refer to the manual of your Pocket PC for information
on what COM-port to select for Bluetooth connections.
4. If you are using a GPS receiver of another brand than
NAVIGON (Type: Other receiver), enter the respective Baud
rate into the Baud field.
5. The blue LED at the GPS receiver shines when the connection
is established.
6. Leave the GPS receiver connected to the power supply for
about 2 hours in order to fully charge its battery.
9.2 Annex B: Problem solutions
9.2.1 Performance
Slow calculation Route calculation is very slow; the voice indications in navigation
mode are coming late.
The efficiency of both route calculation and navigation depends
on the amount of free memory and on the kind of memory card
you use.
In order to navigate properly, the system should dispose of at
least 15MB of free memory on your Pocket PC.