Filter
Top Products
Basic Operations
Starting the NAVIGON 7100
16 NAVIGON 7100 User’s Guide January 2008
NAVIGON, INC. Revision 2.0
Initializing the GPS receiver
As soon as the navigation device has been switched on, initialization of the GPS
receiver begins.
In the upper right-hand corner of the display, the
GPS symbol appears. As soon as
data from at least 3 satellites is received, the symbol changes to GPS Ready.
Setting the volume
The volume of the spoken driving instructions can be adjusted during navigation.
With a map displayed:
1. Tap (
Volume) to open the volume bar.
The volume bar opens. It contains three buttons for adjusting the volume:
(
Louder), (Quieter), (Volume on/off).
2. Tap (
Volume) to close the Volume bar.
Note:
It can take up to 20 minutes to initialize the integrated GPS receiver for the first
time.
Each time you turn on the device, GPS reception starts within one minute.
If the navigation device has been switched off for more than a week, the next initializa-
tion can take up to 10 minutes.
Note: If the GPS symbol displays GPS Ready after considerably less than 20 minutes,
it is advisable to leave the receiver switched on for at least 15 minutes to ensure reliable
operation.
Caution! If you have connected the navigation device to the power supply via the vehi-
cle's cigarette lighter, remove the connector before you leave the vehicle for a long
period of time.
As the GPS receiver requires a constant supply of power, it could drain the vehicle´s bat-
tery.