Navigon 7100 GPS Receiver User Manual


 
Getting Started
Preparing Your NAVIGON 7100 for Use
January 2008 NAVIGON 7100 User’s Guide 11
Revision 2.0 NAVIGON, INC.
Inserting a memory card
The SD memory card contains maps and navigation software. It also stores saved
destinations, routes, and logbook entries.
Insert the memory card provided into the slot on the top of the device (see image).
Press the card into the device until it locks into place.
Removing a memory card
1. Switch the navigation device off by pressing the (On/Off/Standby) switch for at
least 6 seconds.
2. Press the memory card gently into the device until the lock disengages.
Securing the cradle
Clean and dry the windshield as well as the suction cup on the base of the cradle.
These areas must be dry and free of dirt and grease.
1. Use the suction cup to affix the cradle to the windshield. The cradle should be as
level as possible.
2. Press the lever on the suction cup down to secure the cradle.
Securing the navigation device to the cradle
The navigation device is secured to the cradle by means of a bayonet fitting. This con-
nection functions in a similar way to attaching a lens to a camera.
1. Place the navigation device on the bayonet in such a way that the bulges on the
bayonet ring correspond exactly with the recesses on the cradle. This is achieved
by rotating it approx. 30° to the left.
2. Turn the navigation device clockwise until the bayonet fitting locks into place.
3. Adjust the navigation device so that it can be seen easily.