Filter
Top Products
6G7 ENGINE (E-W) -
Crankshaft, Flywheel and Drive Plate
11A-13-6
(4) Check the end play. If it exceeds the limit value, replace
the thrust bearing.
Standard value: 0.05 - 0.25 mm
Limit: 0.3 mm
"
C
A
CRANKSHAFT REAR OIL SEAL
(1) Using the Special Tool, press-fit a new crankshaft rear
oil seal into the seal case.
"
D
A
OIL SEAL CASE
(1) Squeeze out a 3 mm bead of liquid gasket (FIPG) and
apply it to the coating surface.
Liquid gasket:
MITSUBISHI GENUINE Part No. MD970389
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation
7EN0034
7EN0465
MD998718
Oil seal
case
7EN0467