Filter
Top Products
6G7 ENGINE (E-W) -
Timing Belt
11A-6-6
(9) Set the Special Tool and a torque wrench on the tensioner
pulley.
(10) Torque the tensioner pulley to 4.4 Nm.
(11)While holding the tensioner pulley, tighten its centre bolt
to the specified torque.
(12) Turn the crankshaft 2 turns clockwise and let it stand
for approx. 5 minutes.
(13) Remove the wire, which was inserted when installing the
tensioner, from the auto tensioner. If it can be removed
easily, the timing belt tension is correct. Make sure that
the auto tensioner rod projection is within specification.
Standard value: 3.8 - 5.0 mm
(14) If the wire cannot be removed easily or the rod protrusion
is not to specification, repeat steps 9 through 12 to obtain
the correct tension.
"
D
A
ENGINE SUPPORT BRACKET
(1) Tighten bolts to specified torque in the sequence shown.
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation
7EN0746
MB998767
7EN0747
7EN0873