Filter
Top Products
6G7 ENGINE (E-W) -
Intake Manifold
11A-7-3
"
F
A
INTAKE MANIFOLD
(1) Tighten the nuts on the right bank to 5 - 8 Nm.
(2) Tighten the nuts on the left bank to the specified torque.
Then tighten the nuts on right bank to the specified torque.
(3) Tighten the nuts on the left bank and those on the right
bank again in that order.
"
G
A
INJECTOR
(1) Apply a small amount of engine oil to the O-ring.
Caution
D
Take care to prevent the engine oil from entering
the delivery pipe.
(2) Install the injector into the delivery pipe and turn it right
and left.
(3) Make sure the injector turns smoothly. If not, the O-ring
may be caught. Remove the injector andcheck fordamage
to the O-ring, then re-insert it and confirm that it turns
smoothly.
(4) When installing the injector, set the delivery pipe setting
mark and the injector projecting portion.
"
H
A
FUEL PRESSURE REGULATOR
(1) Apply a small amount of new engine oil to the O-ring,
then insert the fuel pressure regulator into the delivery
pipe, taking care not to damage the O-ring.
Caution
D
Take care to prevent engine oil from entering the
delivery pipe.
(2) Make sure the regulator turns smoothly. If not, the O-ring
may be caught. Remove the regulator and check for
damage to the O-ring, then re-insert it into the delivery
pipe and confirm that it turns smoothly.
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation
7IN0090
Front
7FU0611
6AE0062
Setting
mark
Projection portion