Filter
Top Products
6G7 ENGINE (E-W) -
Oil Pan and Oil Pump
11A-11-3
(2) Check for side clearance.
Standard value: 0.04 - 0.10 mm
(3) Check for body clearance.
Standard value: 0.10 - 0.18 mm
Limit: 0.35 mm
INSTALLATION SERVICE POINTS
"
A
A
OIL PUMP INNER AND OUTER ROTORS
(1) Install the oil pump outer rotor in the proper direction using
the setting mark drawn on it before disassembly.
Apply engine oil over the entire rotor surface.
"
B
A
OIL PUMP CASE
(1) Remove th e old liquid gasket from the cylinder block (oil
pump mounting surface) an d from the oil pump.
(2) Squeeze out about 3 mm of liquid gasket (FIPG) and
coat the coating surface with it.
Specified sealant:
MITSUBISHI GENUINE Part No. MD970389 or
equivalent
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation
7EN0511
7EN0512
7EN0509
Alignment marks
7EN0767