Filter
Top Products
6G7 ENGINE (E-W) -
Specifications
11A-1-1
1. SPECIFICATIONS
SERVICE SPECIFICATIONS
Items Standard Limit
Timing belt
Auto-tensioner rod length mm 3.8 - 5.0 -
Auto-tensioner rod projection length mm 12 -
Auto-tensioner rod pushed-inamount (when pushed witha force of 98
- 196 N) mm
1.0 or less -
Rocker arms and camshaft
Camshaft cam height mm (Identification
Intake 37.71 37.21
mark: 1)
Exhaust 37.14 36.64
Camshaft journal outside diameter mm 45 -
Lash adjuster leak down time
[diesel fuel at 15 - 20_C] seconds/mm
4 - 20/1.0 -
Cylinder head and valves
Cylinder head flatness of gasket surface mm Less than 0.03 0.2
Cylinder head grinding limit of gasket surface mm
(Total resurfacing depth of both cylinder head and cylinder block)
- 0.2
Cylinder head overall height mm 120 -
Valve thickness of valve head (margin) mm
Intake 1.0 0.5
Exhaust 1.2 0.7
Valve overall height mm
Intake 112.30 111.80
Exhaust 114.11 113.61
Valve stem outside diameter mm
Intake 6.0 -
Exhaust 6.0 -
Valve thickness to valve guide clearance mm
Intake 0.02 - 0.04 0.10
Exhaust 0.04 - 0.06 0.15
Valve face angle mm 45_ - 45.5_ -
Valve spring free length mm 51.0 50.0
Valve spring load/installed height N/mm 267/44.2 -
Valve spring out-of-squareness 2_ or less Maximum 4_
Valve seat valve contact width mm 0.9 - 1.3 -
Valve guide inside diameter mm 6.0 -
Valve guide projection from cylinder head upper surface mm 14 -
Valve stem projection mm 49.3 49.8
Oil pan and oil pump
Oil pump tip clearance mm 0.06 - 0.18 -
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation