Filter
Top Products
6G7 ENGINE (E-W) -
Oil Pan and Oil Pump
11A-11-5
"
E
A
OIL PAN (LOWER)
(1) Clean the gasket coating surfaces of the oil p a n upper
and the oil pan lower.
(2) Squeeze out a 4 mm bead of liquid gasket and coat the
coating surface with it.
Liquid gasket:
MITSUBISHI GENUINE Part No. MD970389 or
equivalent
"
F
A
OIL FILTER
(1) Clean the oil filter attaching surface on the side of the
cylinder block.
(2) Apply engine oil to the O-ring for the oil filter.
(3) Screw in the oil filter and from the point at which the
O-ring contacts the oil filter attaching surface, tighten it
by about one turn (at approx. 14 Nm).
"
G
A
OIL PRESSURE SWITCH
Sealer: 3M ATD Part No. 8660 or equivalent
NOTE
D Sealer mustnot extendbeyond thetip ofthe thread portion.
D Take care not to tighten the switch too much.
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation
View from above
lower oil pan
Flange bolt tightening sequence
View from the bottom of the lower oil pan
7EN0894
5
1
3
7
9
4
2
6
10
8
6EN0591
Bracket side
Engine oil
9EN0094