Filter
Top Products
6G7 ENGINE (E-W) -
Piston and Connecting Rod
11A-12-2
REMOVAL SERVICE POINTS
A
A
"
CONNECTING ROD CAP
(1) Enter the cylinder No. on the side of the large end of
the connecting rod to facilitate reassembly.
A
B
"
PISTON PIN
The special piston pin setting tool (MD998780) consists of
the parts shown at left.
(1) Insert the special push rod tool from the front marked
(arrow) side of the piston side and attach guide C.
(2) Set the piston and connecting rod assembly to t he special
tool piston pin setting base such that the front mark on
the piston faces upward.
(3) Pull out the piston pin with a press.
NOTE
After pulling out the piston pin, place the piston, the piston
pin, and the connecting rod in order for each cylinder
number.
PWEE9615
E
Dec. 1996Mitsubishi Motors Corporation
7EN0448
Cylinder No.
7EN0431
Push rod
Base
Guide B
Guide C
Guide A:
17.9 mm
Guide A:
18.9 mm
Guide A:
20.9 mm
Guide A:
21.9 mm
7EN0390
Push rod
Front mark
Guide C
Base
Front
mark