Filter
Top Products
4G6 ENGINE (E-W) -
Front Case, Counterbalance Shafts and Oil Pan
11A-10-4
(3) Loosen the flange bolt.
A
F
"
COUNTERBALANCE SHAFT FRONT BEARING
REMOVAL
(1) Using the special tool, remove the counterbalance shaft
front bearing from the cylinder block.
NOTE
Be sure to remove the front bearing first.
If it has not been removed, the Rear Bearing Puller cannot
be used.
A
G
"
COUNTERBALANCE SHAFT REAR BEARING
REMOVAL
(1) Using the special tool, remove the left counterbalance
shaft rear bearing from the cylinder block.
NOTE
When removing the left counterbalance shaft rear bearing,
install the special tool (MB991603) in front of the cylinder
block.
INSTALLATION SERVICE POINTS
"
A
A
RIGHT COUNTERBALANCE SHAFT REAR
BEARING INSTALLATION
(1) Apply engine oil to the outer surface of bearing.
(2) Using special tools, install right rear bearing. Make sure
that oil hole of bearing is aligned with oil hole of cylinder
block.
RevisedPWEE9616-A
E
Aug. 1998Mitsubishi Motors Corporation
6EN0565
MB991603
6EN1034
MD998705