Filter
Top Products
4G6 ENGINE (E-W) -
Timing Belt
11A-4-4
A
D
"
CRANKSHAFT BOLT LOOSENING
(1) Hold the drive plate with the special tool as shown.
(2) Remove the crankshaft bolt.
A
E
"
CRANKSHAFT SPROCKET REMOVAL
(1) If it is difficult to remove the sprocket, use the special
tool.
A
F
"
TIMING BELT “B” REMOVAL
(1) Make a mark on the back of the timing belt indicating
the direction of rotation so it may be reassembled in the
same direction if it is to be reused.
NOTE
(1) Water or oil on the belt shortens its life drastically,
so the removed timing belt, sprocket, and tensioner
must be free from oil and water. These parts should
not be washed. Replace parts if seriously
contaminated.
(2) If there is oil or water on each part check front case
oil seals, camshaft oil seal and water pump for leaks.
A
G
"
COUNTERBALANCE SHAFT SPROCKET
REMOVAL
(1) Set the special tool as shown to prevent the
counterbalance shaft sprocket from turning together.
(2) Loosen the bolt and remove the sprocket.
RevisedPWEE9616-A
E
Aug. 1998Mitsubishi Motors Corporation
6EN1322
MD998785