Filter
Top Products
4G6 ENGINE (E-W) -
Rocker Arms and Camshafts (GDI)
11A-8a-3
(5) Install the beam camshaft cap before the sealant applied
becomes dry and hard.
(6) Tighten the bolts to the specified torque in the order shown
in the illustration.
Specified torque: 20 Nm
(7) Install the camshaft oil seal before the sealant applied
becomes dry and hard.
(8) Wipe off squeezed out excess sealant from the
circumference of the beam camshaft cap.
"
C
A
CAMSHAFT POSITION SENSING CYLINDER
SUPPORT INSTALLATION
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
the area shown.
Specified sealant:
Mitsubishi genuine Part No. MD970389 or
equivalent
"
D
A
CAMSHAFT POSITION SENSING CYLINDER
INSTALLATION
(1) Set the No. 1 cylinder to the compression top dead center
position (so that dowel pin of the exhaust camshaft is
at the top).
(2) Install the camshaft position sensing cylinder so that the
white paint mark is facing in the direction shown in the
illustration.
INSPECTION
CAMSHAFT
(1) Measure the cam height.
Standard value:
Intake 35.79 mm
Exhaust 37.14 mm
Limit:
Intake 35.29 mm
Exhaust 36.64 mm
AddedPWEE9616-A
E
Aug. 1998Mitsubishi Motors Corporation
Timing belt side
MD998713
Camshaft
position
sensor
Paint mark