Filter
Top Products
67
MAP CARTRIDGE
BOUNDARY
(Note: This only works on the speed sensor connected to the sonar
module. You cannot calibrate the speed from the GPS module or NMEA
which is displayed in the “SOG” window.
To reset the distance log to zero, simply press the key next to the “Reset
Dist. Log” label. The current distance log is shown to the right of this menu.
(Note: The distance log gets its information from the sonar module’s speed
sensor only.)
The water temperature graph shown at the bottom of this page has a ten
degree range as its default. For example, in the screen shown above, the
temperature graph range is from 70 to 80 degrees, a ten degree range. You
can change this range to 2 or 4 degrees by pressing the key next to the
“Graph Range”.
MAP BOUNDARIES
When you are using a Low-
rance IMS SmartMap™ or C-
MAP map cartridge, the
GlobalMap 2000 automatically
displays the map’s boundaries
as shown at right. To turn this
feature off, press the MENU
key, then press the key next to
the “Mapping Setup” label. Now
press the key next to the “More”
label. The screen shown below
appears. Now press the key
next to the “Map Boundaries”
label. Press the CLR key to
erase this menu. Repeat these
steps to turn the boundaries
on.