Filter
Top Products
17
Pole Mount
First, thread the pole mounting adapter onto the mounting pole or ratchet
base. Align the pole mounting adapter so the module will face the bow of
the boat. Install and tighten the set screw into the pole mounting adapter
and tighten it securely. This should prevent the GPS module from
unscrewing from the pole. Place the gasket onto the pole mounting
adapter. Now attach the cable to the GPS module and pass the cable
through the gasket, pole mounting adapter, and pole. Set the GPS module
on top of the pole mounting adapter and align the four threaded holes in the
module with the holes in the pole mounting adapter. Using the four
stainless steel 5 mm screws and lock washers supplied with the LGC-1,
attach the pole mounting adapter to the GPS module. This completes the
assembly. If the pole or mast you’re using isn’t hollow or if the hole in the
middle of the pole is too small for the connectors, use the cable mounting
adapter supplied with your unit. Thread the cable mounting adapter into the
GPS pole mounting adapter. Then thread the pole into the cable mounting
adapter. Route the cable down the outside of the pole.
CABLE
MOUNTING
ADAPTER
POLE
POLE
CABLE
MOUNTING
ADAPTER
GPS
MODULE
SET
SCREW
POLE
MOUNTING
ADAPTER
POLE
GPS
MODULE