Filter
Top Products
50
sequences to the next waypoint. Navigation information is shown to this
waypoint and the process repeats. When you reach the last waypoint in a
route, the arrival alarm sounds until you turn it off.
There are four steps required to create and follow a route. First, you must
create and name the route. Next, select the waypoints used in the route.
Then determine the starting waypoint. Next, tell the unit to follow the route.
Finally, the unit will ask you if you wish to run the route forward or backward.
After these steps are completed, the mapping unit will start showing
navigation data to the first waypoint on the route.
You can create a route from the list of waypoints or directly from the map.
CREATING A ROUTE
Name a Route
To create a route, first press the WAYPT/ROUTE key . Next, press the key
next to the “Routes” label. The screen shown below appears.
This menu lets you create a
route, edit an existing route,
run a route, erase it, and set the
auto-sequencing and arrival
radius. To create the route,
press the key next to the “Cre-
ate Route” label. The screen
shown at right appears. This is
the “name route” menu. Press
a key next to the label that has
the desired letter repeatedly
until the first letter in the route
name appears. Now press the
right arrow key once. Select
the next letter in the route name,
then press the right arrow key
again. Continue in this manner
until the route name has been
entered. (Note: To enter a
space, press the key next to
the “Z ,.’” label. The space is
the character after the “Z”.)
When the name appears as
you wish, press the ENT key.
The screen at the top of the
next page appears.