Filter
Top Products
LT77S
I
'8:
i
..
,I
BELL HOUSING
-
FOUR CYLINDER ENGINE
MANUAL
GEARBOX
BELL HOUSING
-
V8
ENGINE
1.
Fit bellhousing locating over hollow dowels and
secure with bolts.
1.
Fit bell housing locating
on
hollow dowels.
NOTE: Fit the
12
x
45
mm bolts through
dowels and
12
x
30 mm bolts
in
remaining positions.
2.
Secure pivot post.
3.
Apply molybdenum disulphide grease to pivot
post, lever pads and pins.
4.
Assemble pads to lever and lever to bearing
and fit assembly to pivot post.
5.
Fit staple to release assembly, short leg to
lever.
NOTE: The staple is an aid to assembly
only which may become dislodged
or
lost in service without detriment.
NOTE: Fit the
12
x
45" bolts through
dowels and
12
x
30" bolts in remaining
positions.
2.
Apply molybdenum disulphide grease to pivot
post, release lever, socket and push
rod.
Not
the bearing guide.
3.
Fit
'C'
washer to pivot post.
4.
Fit spring clip to lever and fit lever to pivot post.
NOTE: Position spring clip behind 'C'
washer and tighten screw.
5.
Fit bearing and retain with plastic staple.
ST2202M
4
4
4
L
ST3286M