Filter
Top Products
1
37
MANUALGEARBOX DEFENDER
3. Fit first
-
second synchromesh hub, fork groove
8.
Fit first gear bush.
4.
Fit circlip.
10.
Fit
circlip.
uppermost.
9.
Fit dummy bearing.
ST3231
M
-
First
-
second synchromesh assembly
S
T3
2
57M
5.
Fit first gear inner and outer baulk ring.
6.
Fit cone.
7. Fit spacer.
11.
Check clearance between dummy bearing and
bush.
Not
to
exceed 0,75mm (0.003in).
12.
Remove circlip, dummy bearing and bush.
9
8
7
1---7
ST3
253M
I
I
Selective first gear bush
Part number Thickness
FTC2005
FTC2006
FTC2007
FTC2008
FTC2009
30,905/30,955
30,955131,005
31,005131,055
31,055/31,105
31
,
1
05/31
,155
Check first gear to bush end
-
float.
1.
Fit roller bearing and bush
to
first gear.
2. Place bush flange side downwards on a raised
block on a flat surface.
NOTE:
the block should be approximately
the same diameter as the bush flange
so
that the gear is suspended and does not
rest
on
the flat surface.