Filter
Top Products
LT77S MANUAL
GEARBOX
OVERHAUL
2
>
-
I
:
FITTING GEARBOX CASING
27
1.
Turn selector shaft and spool
to
neutral
2.
Fit out
-
board detent ball and sprlng and secure
position.
with plug.
ST2494M
2
3.
Fit guide studs to casing and check
oil
scoop
I
S
4.
Without using force, fit gearcase.
correctly fitted.
NOTE: Ensure that the centre plate
dowels and selector shaft are properly
located.
5.
Secure centre plate and gearcase to workstand
6.
Apply PL
32
to joint face and bolt threads and
with two
8
x
35" bolts.
fit
spool retainer.
ST2515M
CAUTION:,Do not use force to fit retainer.
A
Provided the spool has not been
disturbed the retainer will slide into
position.
If
not, remove the gear case and
reposition spool
or
shaft.
7.
Remove detent plug, apply Loctite 290 or
Hylomar PL
32
to thread, refit and stake.
8.
Fit
layshaft and input shaft bearing tracks.