Filter
Top Products
137
MANUALGEARBOX
DEFENDER
NOTE: If necessary, final adjustment can
be made
in
vehicle. To increase pull-over
load turn screw clockwise
or
anti
-
clockwise to reduce load.
Fifth gear stop screw adjustment.
1.
Adjust screw to protrude from housing the
distance across corners
of
locknut.
NOTE: This is only an approximate
setting which will limit travel of selector
yoke but will allow fifth gear to be
selected.
/
------
//
LA
ST3225M
L
I
Bias spring adjustment
NOTE: The purpose of this adjustment is
A
to set both bolts
so
that the bias spring
legs apply equal pressure on both ends
of the gear lever cross pin when third or fourth
gear is engaged. This will ensure that when
the
lever is
in
neutral, the gear change mechanism
is automatically aligned for
third
or fourth gear
selection.
1.
Select fourth gear and
lift
both spring legs over
the cross pins.
2.
Turn adjustment
bolts
until heads touch spring
legs.
3.
Apply light pressure
to
gear lever to the right
and adjust left hand bolt.
,jy
4%
$-:'
NOTE: Clearance between spring leg and
bolt
0,05
mm
(0.002
in.) using feeler
gauge.
2.
Select fifth gear. While applying light pressure
to
gear lever towards right, turn screw
clockwise until it contacts yoke. Turn screw half
a
turn anti- clockwise and tighten nut.
ST2198M
4.
Move lever to left and adjust right hand bolt
to
clearance.
5.
Tighten locknuts.