Filter
Top Products
LT77S
MANUAL
GEARBOX
MAINSHAFT GEAR END FLOAT CHECKS
Third gear end
-
float.
1.
Hold mainshaft in vice front end downwards.
2.
Fit front circlip
for
first
-
second synchromesh.
3. Fit second gear cone.
4.
Fit spacer.
5.
Fit snap ring.
1.
Fit needle roller
to
third gear.
2.
fit third gear bush
to
third gear.
3.
Place gear
on
flat surface, bush flange
downwards, and with
a
straight edge across
gear check clearance between straight edge
and gear.
Not
to exceed
0,20
(0.008in).
ST3235M
ST3251
M
Second gear end
-
float.
First
gear bush end
-
float.
1.
Fit needle roller and second gear
2.
Fit third gear bush.
3.
Check clearance between second gear and
bush flange.
Not
to
exceed 0,20
(0.008in).
4.
Remove above components.
1.
Invert mainshaft rear end uppermost.
2.
Fit inner and outer second gear baulk rings.
ST3252M
'
'I\\
OVERHAUL
1
19