Filter
Top Products
0
0
22
0
0
11
MAINTENANCE WORK ON CHASSIS AND ENGINE 68
9.18Adjusting handlebar positionx
400271-10
– Remove the four screws. Remove the handlebar clamp. Remove the handlebar and
lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
– Remove the two screws. Remove the handlebar support.
– Place the handlebar support in the required position. Fit and tighten the two screws.
Specification
Screw, handlebar support M10 40Nm (29.5lbfft)
Info
Position the left and right handlebar supports evenly.
– Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
– Position the handlebar clamp. Fit and evenly tighten the four screws.
Specification
Screw, handlebar clamp M8 20Nm
(14.8lbfft)
Loctite
®
243™