KTM 690 ENDURO EU Motorcycle User Manual


 
MAINTENANCE WORK ON CHASSIS AND ENGINE 104
100277-10
Disconnect the negative (minus) cable of the battery.
Pull off connector in an upward direction.
Remove screws.
Pull retaining bracket of the battery forward and remove it.
Take off the positive terminal cover.
Disconnect the positive (plus) cable of the battery.
Press the wiring harness to one side and pull the battery out of the battery rack.
Info
Never operate the motorcycle with a discharged battery or without a battery. In
both cases, electrical components can safety equipment can be damaged. The
vehicle is then no longer safe to ride.
9.51Installing the batteryx
100277-11
Slide the battery into the battery rack.
Info
The battery terminals must be at the rear.
Attach the positive cable and mount positive terminal cover.
Position retaining bracket.
Mount and tighten screws.
Specification
Remaining screws, chassis M6 10Nm (7.4lbfft)
Plug in connector.
Attach the minus cable.
Mount the seat. ( P. 103)