Filter
Top Products
TECHNICAL DATA - ENGINE TIGHTENING TORQUES 156
Screw, cylinder head M10 Tightening sequence:
Tighten diagonally, beginning
with the rear screw on the
chain shaft.
Step 1
15Nm (11.1lbfft)
Step 2
30Nm (22.1lbfft)
Step 3
45Nm (33.2lbfft)
Step 4
60Nm (44.3lbfft)
lubricated with engine oil
Spark plug M12x1,25 17Nm (12.5lbfft) –
Coolant temperature sensor on cylinder
head
M12x1.5 12Nm (8.9lbfft) –
Oil drain plug with magnet M12x1,5 20Nm (14.8lbfft) –
Oil pressure regulator valve plug M12x1.5 20Nm (14.8lbfft) –
Plug, oil bore M14x1,5 15Nm (11.1lbfft)
Loctite
®
243™
Engine case stud M16x1.5 25Nm (18.4lbfft)
Loctite
®
243™
Ignition rotor nut M18x1,5 100Nm (73.8lbfft) –
Nut, engine sprocket M20x1,5 60Nm (44.3lbfft)
Loctite
®
243™
Nut, inner clutch hub M20x1,5 100Nm (73.8lbfft)
Loctite
®
243™
Nut, primary gear M20LHx1,5 100Nm (73.8lbfft)
Loctite
®
243™
Plug, oil screen M20x1,5 15Nm (11.1lbfft) –
Plug, timing chain tensioner M20x1,5 25Nm (18.4lbfft) –
Screw in generator cover M24x1.5 8Nm (5.9lbfft) –
Plug, oil thermostat M24x1,5 15Nm (11.1lbfft) –