KTM 690 ENDURO EU Motorcycle User Manual


 
0
0
BB
0
0
AA
MAINTENANCE WORK ON CHASSIS AND ENGINE 67
9.16Adjusting the handlebar anglex
100279-10
Loosen screw.
Move the handlebar to the desired position and slightly tichten the screws.
Move the handlebar carefully in both directions as far as it will go.
» If the handlebar instruments touch the fuel tank:
Correct the handlebar angle.
Info
The distance between the handlebar support and the handlebar clamp
must be the same at the front and rear.
Fully tighten screw.
Specification
Screw, handlebar clamp M8 20Nm
(14.8lbfft)
Loctite
®
243™
9.17Handlebar position
400271-11
On the upper triple clamp, there are 2 holes at a distance to each other.
Distance between holes 15mm (0.59in)
The holes on the handlebar support are placed at a distance from the center.
Distance between holes 3.5mm (0.138in)
The handlebar can be mounted in 4 different positions. In this way, the handlebar can be
installed in the position most comfortable for the rider.