Filter
Top Products
The following abbreviations are used to represent values for Control Module Pin-Out data
I Input SG Sensor Ground S SCP Network V Voltage (DC)
O Output A ACP Network D Serial and Encoded Data Hz Frequency
SS Sensor Supply V C CAN (Network) B+ Battery Voltage kHz Frequency x 1000
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all components
connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
Refer to the front of this book for detailed information and illustrations regarding the location and identification of harnesses, relays, grounds, control
modules and control module pins.
DATE OF ISSUE: September 2000
Fig. 11.3
COMPONENTS
Component Connector / Type / Color Location / Access
BODY PROCESSOR MODULE FC15 / 14-WAY AMP EEEC / GREY BULKHEAD / BEHIND GLOVE BOX
DOOR CONTROL MODULE – DRIVER REAR RD10 / 22-WAY FORD 2.8 TIMER / BLUE DOOR CASING / TRIM PANEL
RD11 / 22-WAY FORD 2.8 TIMER / BLACK
DOOR CONTROL MODULE – DRIVER DD10 / 22-WAY FORD 2.8 TIMER / BLUE DOOR CASING / TRIM PANEL
DD11 / 22-WAY FORD 2.8 TIMER / BLACK
DOOR CONTROL MODULE – PASSENGER PD10 / 22-WAY FORD 2.8 TIMER / BLUE DOOR CASING / TRIM PANEL
PD11 / 22-WAY FORD 2.8 TIMER / BLACK
DOOR MIRROR MOTORS – DRIVER DD8 / 12-WAY MULTILOCK 040 / BLACK DRIVER DOOR
DOOR MIRROR MOTORS – PASSENGER PD8 / 12-WAY MULTILOCK 040 / BLACK PASSENGER DOOR
MIRROR JOYSTICK DD1 / 26-WAY AMP MICRO QUAD LOCK / YELLOW DOOR TRIM PANEL
(DRIVER DOOR SWITCH PACK)
MIRROR SELECT SWITCH DD1 / 26-WAY AMP MICRO QUAD LOCK / YELLOW DOOR TRIM PANEL
(DRIVER DOOR SWITCH PACK)
HARNESS-TO-HARNESS CONNECTORS
Connector Type / Color Location / Access
CA8 20-WAY MULTILOCK 070 / WHITE DRIVER ‘A’ POST / DOOR HARNESS GAITER
CA10 8-WAY MULTILOCK 070 / YELLOW DRIVER ‘A’ POST / DOOR HARNESS GAITER
CA11 20-WAY MULTILOCK 070 / WHITE PASSENGER ‘A’ POST / DOOR HARNESS GAITER
CA12 8-WAY MULTILOCK 070 / YELLOW PASSENGER ‘A’ POST / DOOR HARNESS GAITER
CA13 4-WAY MULTILOCK 070 / WHITE DRIVER ‘B/C’ POST / DOOR HARNESS GAITER
CA14 6-WAY MULTILOCK 070 / WHITE DRIVER ‘B/C’ POST / DOOR HARNESS GAITER
FC1 54-WAY THROUGH PANEL CONNECTOR / GREY BELOW PASSENGER SIDE AIR VENT / GLOVE BOX ASSEMBLY
FC5 54-WAY THROUGH PANEL CONNECTOR / GREY BELOW DRIVER SIDE AIR VENT / COIN TRAY
GROUNDS
Ground Location / Type
CA30R EYELET (PAIR) – LH ‘A’ POST GROUND SCREW
CA33L EYELET (PAIR) – RH ‘A’ POST GROUND SCREW
CA33R EYELET (PAIR) – RH ‘A’ POST GROUND SCREW
CA36L EYELET (PAIR) – LH ‘A’ POST GROUND SCREW
FOR CONTROL MODULE PIN OUT INFORMATION, UNFOLD PAGE TO LEFT.
CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
Pin Description Active Inactive
I FC15-15 IGNITION SWITCHED GROUND GROUND B+
I FC15-32 IGNITION SWITCHED GROUND GROUND B+
I FC15-41 STARTER ENGAGE REQUEST GROUND (CRANKING) B+
I FC15-80 BATTERY SUPPLY VOLTAGE B+ B+
S FC15-84 SCP NETWORK 2 – 1600 Hz
S FC15-85 SCP NETWORK 2 – 1600 Hz
O FC15-101 ILLUMINATION BATTERY SUPPLY VOLTAGE B+ B+
DRIVER DOOR CONTROL MODULE
Pin Description Active Inactive
I DD10-1 BATTERY POWER SUPPLY B+ B+
O DD10-2 DRIVER DOOR MIRROR B+ = LEFT / DOWN; GROUND = RIGHT / UP
VERTICAL / HORIZONTAL MOTOR COMMON SUPPLY
O DD10-3 DRIVER DOOR MIRROR HORIZONTAL MOVEMENT MOTOR B+ = RIGHT GROUND = LEFT
O DD10-4 DRIVER DOOR MIRROR VERTICAL MOVEMENT MOTOR B+ = UP GROUND = DOWN
I DD10-8 LOGIC GROUND GROUND GROUND
S DD10-9 SCP NETWORK 2 – 1600 Hz
S DD10-16 SCP NETWORK 2 – 1600 Hz
I DD10-17 POWER GROUND GROUND GROUND
I DD11-1 MIRROR COMMON GROUND GROUND GROUND
I DD11-3 LH VERTICAL MOVEMENT REQUEST B+ = DOWN GROUND = UP
I DD11-5 PASSENGER MIRROR SELECT B+ GROUND
I DD11-9 RH VERTICAL MOVEMENT REQUEST B+ = DOWN GROUND = UP
I DD11-10 LH HORIZONTAL MOVEMENT REQUEST B+ = LEFT GROUND = RIGHT
I DD11-13 DRIVER MIRROR SELECT B+ GROUND
I DD11-17 RH HORIZONTAL MOVEMENT REQUEST B+ = LEFT GROUND = RIGHT
PASSENGER DOOR CONTROL MODULE
Pin Description Active Inactive
I PD10-1 BATTERY POWER SUPPLY B+ B+
O PD10-2 PASSENGER DOOR MIRROR B+ = LEFT / DOWN GROUND = RIGHT / UP
VERTICAL / HORIZONTAL MOVEMENT MOTORS COMMON
O PD10-3 PASSENGER DOOR MIRROR HORIZONTAL MOVEMENT MOTOR B+ = RIGHT GROUND
O PD10-4 PASSENGER DOOR MIRROR VERTICAL MOVEMENT MOTOR B+ = UP GROUND
I PD10-8 LOGIC GROUND GROUND GROUND
S PD10-9 SCP NETWORK 2 – 1600 Hz
S PD10-16 SCP NETWORK 2 – 1600 Hz
I PD10-17 POWER GROUND GROUND GROUND
NOTE: Refer to the Appendix at the rear of this book for CAN and SCP Network messages.