Filter
Top Products
The following abbreviations are used to represent values for Control Module Pin-Out data
I Input SG Sensor Ground S SCP Network V Voltage (DC)
O Output A ACP Network D Serial and Encoded Data Hz Frequency
SS Sensor Supply V C CAN (Network) B+ Battery Voltage kHz Frequency x 1000
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all components
connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
Refer to the front of this book for detailed information and illustrations regarding the location and identification of harnesses, relays, grounds, control
modules and control module pins.
DATE OF ISSUE: September 2000
Fig. 08.2
COMPONENTS
Component Connector / Type / Color Location / Access
AUDIBLE WARNING SPEAKER (COLUMN SWITCHGEAR) SC7 / HARDWIRED COLUMN SWITCHGEAR HARNESS / ADJACENT TO STEERING COLUMN MOTOR
BODY PROCESSOR MODULE FC15 / 14-WAY AMP EEEC / GREY BULKHEAD / BEHIND GLOVE BOX
SEAT BELT SWITCH SD8 / 2-WAY MULTILOCK 070 / BLACK DRIVER SEAT
HARNESS-TO-HARNESS CONNECTORS
Connector Type / Color Location / Access
CA23 10-WAY MULTILOCK 070 / WHITE BELOW DRIVER SEAT
FC5 54-WAY THROUGH PANEL CONNECTOR / GREY BELOW DRIVER SIDE AIR VENT / COIN TRAY
SC1 12-WAY MULTILOCK 070 / WHITE COLUMN SWITCHGEAR
GROUNDS
Ground Location / Type
CA25R EYELET (PAIR) – PASSENGER SEAT GROUND STUD
CA26R EYELET (PAIR) – DRIVER SEAT GROUND STUD
FOR CONTROL MODULE PIN OUT INFORMATION, UNFOLD PAGE TO LEFT.
CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
Pin Description Active Inactive
D FC15-10 SRS AUDIBLE BACKUP ENCODED COMMUNICATIONS
I FC15-15 IGNITION SWITCHED GROUND GROUND B+
I FC15-31 SEAT BELT SWITCH STATUS GROUND (UNFASTENED) B+ (FASTENED)
I FC15-32 IGNITION SWITCHED GROUND GROUND B+
I FC15-41 STARTER ENGAGE REQUEST GROUND (CRANKING) B+
I FC15-80 BATTERY SUPPLY VOLTAGE B+ B+
O FC15-82 AUDIBLE WARNING SPEAKER AUDIO OUTPUT
O FC15-83 AUDIBLE WARNING SPEAKER AUDIO OUTPUT
S FC15-84 SCP NETWORK 2 – 1600 Hz
S FC15-85 SCP NETWORK 2 – 1600 Hz
I FC15-104 BATTERY SUPPLY VOLTAGE B+ B+
NOTE: Refer to the Appendix at the rear of this book for CAN and SCP Network messages.