Filter
Top Products
The following abbreviations are used to represent values for Control Module Pin-Out data
I Input SG Sensor Ground S SCP Network V Voltage (DC)
O Output A ACP Network D Serial and Encoded Data Hz Frequency
SS Sensor Supply V C CAN (Network) B+ Battery Voltage kHz Frequency x 1000
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all components
connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
Refer to the front of this book for detailed information and illustrations regarding the location and identification of harnesses, relays, grounds, control
modules and control module pins.
DATE OF ISSUE: September 2000
Fig. 05.1
COMPONENTS
Component Connector / Type / Color Location / Access
D – 4 SWITCH CC7 / 3-WAY MULTILOCK 070 / YELLOW CENTER CONSOLE ASSEMBLY
GEAR SELECTOR ILLUMINATION MODULE CC14 / 10-WAY MULTILOCK 070 / WHITE CENTER CONSOLE ASSEMBLY
MODE SWITCH (TRANSMISSION) CC4 / 10-WAY AMP MICRO QUAD LOCK / BLACK CENTER CONSOLE ASSEMBLY
TRANSMISSION CONTROL MODULE: AJ27 N/A EM7 / 88-WAY BOSCH / BLACK ENGINE COMPARTMENT / CONTROL MODULE ENCLOSURE
TRANSMISSION ELECTRICAL CONNECTOR: AJ27 N/A EM46 / 16-WAY KOSTAL TRANSMISSION CONNECTOR / BLACK LEFT HAND REAR OF TRANSMISSION
TRANSMISSION ROTARY SWITCH EM47 / 10-WAY METRI-PACK 150 / BLACK ENGINE COMPARTMENT / BRACKET ON TOP OF TRANSMISSION
HARNESS-TO-HARNESS CONNECTORS
Connector Type / Color Location / Access
EM53 20-WAY MULTILOCK 070 / WHITE PASSENGER ‘A’ POST / LOWER ‘A’ POST FINISHER
GROUNDS
Ground Location / Type
CC2R EYELET (PAIR) – DRIVE SHAFT TUNNEL GROUND STUD – LH SIDE
CC3L EYELET (PAIR) – RH FRONT BULKHEAD STUD / CABIN SIDE
EM8R EYELET (PAIR) – EMS LH GROUND STUD
FOR CONTROL MODULE PIN OUT INFORMATION, UNFOLD PAGE TO LEFT.
CONTROL MODULE PIN OUT INFORMATION
GEAR SELECTOR ILLUMINATION MODULE
Pin Description Active Inactive
I CC14-1 IGNITION SWITCHED POWER SUPPLY B+ GROUND
C CC14-3 CAN NETWORK 15 – 1500 Hz @ 2.5 V
C CC14-4 CAN NETWORK 15 – 1500 Hz @ 2.5 V
I CC14-6 GROUND GROUND GROUND
C CC14-8 CAN NETWORK 15 – 1500 Hz @ 2.5 V
C CC14-9 CAN NETWORK 15 – 1500 Hz @ 2.5 V
TRANSMISSION CONTROL MODULE: AJ27 N/A
Pin Description Active Inactive
O EM7-1 PRESSURE REGULATOR #2 GROUND (MAXIMUM PRESSURE) B+ (NO PRESSURE)
O EM7-2 SPORT MODE SWITCH STATUS LED GROUND = LED ON B+
O EM7-4 PRESSURE REGULATOR #4 GROUND (MAXIMUM PRESSURE) B+ (NO PRESSURE)
O EM7-5 PRESSURE REGULATOR #1 GROUND (MAXIMUM PRESSURE) B+ (NO PRESSURE)
I EM7-6 GROUND GROUND GROUND
I EM7-8 ROTARY SWITCH ‘L2’ CONTACTS B+ GROUND
I EM7-9 ROTARY SWITCH ‘L4’ CONTACTS B+ GROUND
I EM7-12 SPORT MODE SWITCH STRATEGY SELECT GROUND = SPORT 9 V = NORMAL
I EM7-13 D – 4 SWITCH GROUND B+
SG EM7-14 TURBINE SPEED SENSOR 300 Hz @ IDLE (2.5 V)
SG EM7-15 OUTPUT SPEED SENSOR SHIELD GROUND GROUND
SG EM7-16 OUTPUT SPEED SENSOR GROUND GROUND
SG EM7-21 FLUID TEMPERATURE SENSOR 1.31 V
I EM7-22 FLUID TEMPERATURE SENSOR FEEDBACK 1.15 V @ 90°C
SG EM7-23 TURBINE SPEED SENSOR SHIELD GROUND GROUND
I EM7-26 BATTERY POWER SUPPLY B+ B+
SG EM7-28 ROTARY / D – 4 / KICK DOWN SWITCHES COMMON GROUND GROUND GROUND
O EM7-29 PRESSURE REGULATOR #3 GROUND (MAXIMUM PRESSURE) B+ (NO PRESSURE)
O EM7-30 SOLENOID VALVE #1 GROUND B+
O EM7-32 SOLENOID VALVE #3 GROUND B+
O EM7-33 SOLENOID VALVE #2 GROUND B+
I EM7-34 GROUND GROUND GROUND
I EM7-36 ROTARY SWITCH ‘L1’ CONTACTS B+ GROUND
I EM7-37 ROTARY SWITCH ‘L3’ CONTACTS B+ GROUND
I EM7-42 TURBINE SPEED SENSOR 1.51 V @ 10 MPH (16 KM/H) = 250 Hz, 20 MPH (32 KM/H) = 500 Hz
I EM7-44 OUTPUT SPEED SENSOR 1.51 V @ 10 MPH (16 KM/H) = 223 Hz, 20 MPH (32 KM/H) = 446 Hz
I EM7-45 SPORT MODE SWITCH STRATEGY SELECT 10 v = SPORT GROUND = NORMAL
O EM7-51 PRESSURE REGULATOR #5 GROUND (MAXIMUM PRESSURE) B+ (NO PRESSURE)
O EM7-52 SOLENOID VALVES COMMON SUPPLY B+ B+
O EM7-53 PRESSURE REGULATORS COMMON SUPPLY B+ B+
I EM7-54 IGNITION SWITCHED POWER SUPPLY B+ GROUND
I EM7-55 IGNITION SWITCHED POWER SUPPLY B+ GROUND
C EM7-82 CAN NETWORK 15 – 1500 Hz
C EM7-83 CAN NETWORK 15 – 1500 Hz
C EM7-85 CAN NETWORK 15 – 1500 Hz
C EM7-86 CAN NETWORK 15 – 1500 Hz
NOTE: Refer to the Appendix at the rear of this book for CAN and SCP Network messages.