Filter
Top Products
9.6 LOAD CONFIGURATION
The parameters you have set from the various menus (e.g., Comm Port,
Units, Position coordinates) may be saved to a configuration file so they may
be easily re-loaded next time you run the PCX5 program.
Figure 9-8: LOAD CONFIGURATION DIALOG BOX
Select “Load Configuration” to display the Load Configuration dialog box.
Specify the name of the configuration file to load and select “OK”.
Remember that a configuration file may also be loaded from the DOS
command line when starting the PCX5 program (see Section 3.1).
9.7 SAVE CONFIGURATION
Select “Save Configuration” to save the currently selected parameters to a
configuration file. A dialog box will be displayed. Specify the drive, directory
and file name for the configuration file. (The default file name is “PCX5.CFG”.)
Select “OK” to save the configuration file.
9.8 SAVE ON EXIT
A check-mark ( ) next to “Save on Exit” will indicate that this option is active.
The currently selected parameters will automatically be saved to a
configuration file when exiting the PCX5 program. If no other configuration
file has been specified, the parameters will be saved to the default file:
“PCX5.CFG”.
9-6