Garmin GPSMAP 496 GPS Receiver User Manual


 
GPSMAP 496 Owner’s Manual 95
Marine
Marine Mode Pages and Features > Compass Page
Using the Marine Timer
The Marine Timer, specically designed for sail boat racing,
allows you to easily count up or down specied time increments.
As common in sail boat racing, there is often a 5 minute warning
countdown, followed by a 4 minute preparation countdown, and
nally a one minute nal countdown. You must change the Compass
Page layout to use the Marine Timer.
To open the Marine Timer:
1. Press PAGE repeatedly until the Compass Page appears.
2. Press MENU.
3. Use the ROCKER to highlight Set up Page Layout, and press
ENTER.
4. Highlight 2 Columns With Timer, and press ENTER. The Marine
Timer appears in the lower right corner.
To use the Marine Timer:
1. Press the ROCKER up or down to select the time you want to
count. Five (5) minutes is the default.
2. Press ENTER to start the timer. Use the ROCKER during the
timing to quickly select a different length of time.
3. Press ENTER to stop timing.
Marine Timer on the Compass Page
As discussed previously, the timer is set to count down ve minutes.
If you want to change the length of time and the behavior or the
timer, open the Timers Setup tab in the Main Menu.
To set the Marine Timer:
1. Press MENU twice to open the Main Menu.
2. Press the ROCKER down to select Setup and then right to select
the Timers sub tab.
3. Highlight Stop next to Marine, and press ENTER to change the
timer’s behavior. Highlight the behavior you want, and press
ENTER.
4. Highlight the time eld, press ENTER, and then use the
ROCKER to enter a new time. The maximum time is 60:00
(minutes: seconds). Press ENTER when nished.