Filter
Top Products
23
Map Page Options
Reference
• TOTAL TRIP TIME – Total travel time of trip, stopped, and moving
• TRACK – Current compass direction of travel
• TRIP ODOMETER – Trip Odometer
• TURN – Directional amount of turn needed to match bearing
• VELOCITY MADE GOOD – Velocity Made Good to destination
• VOLTAGE – Current voltage reading being received by unit
• WATER SPEED* – Speed through the water
• WATER TEMP. LOG* – Timeline graph of the transducer’s temperature reading.
• WATER TEMPERATURE * – Water temperature
*If receiving proper sonar data from other device, such as a GSD 20 Sounder Module.
NOTE: COMPASS, HIGHWAY, POSITION, and SONAR will only be available on medium and large sized data
fields.
You may also choose to ‘merge’ the four medium, default data fields to a single, large field for better
readability or you may ‘split’ any or all of the default data fields to show 4 small data fields. This option
is available from any of the main pages.
To Split or Merge the Numbers fields:
1. While in ‘Change Numbers’ mode, highlight the data field you want to change and press MENU.
2. Choose ‘Split Number’ or ‘Merge Numbers’, then press
ENTER/MARK. You will now see four new
data fields or one large field. Press
QUIT when done.
3. To return to the factory configuration, repeat the above steps, but instead choose ‘Defaults’, then
press ENTER/MARK. Press QUIT when done.
• Measure Distance— allows you to measure the bearing and distance between any two points on the
map display.
To measure the Bearing/distance between two points:
1. Highlight the ‘Measure Distance’ option and press ENTER/MARK. An on-screen pointer will appear
on the map display at your present position with ‘ENT REF’ below it.
2. Move the cursor to the desired reference point (the point that you want to measure from) and press
ENTER/MARK.
3. Mov
e the cursor to the point that you want to measure to. The bearing and distance from the refer-
ence point and cursor coordinates will be displayed in the data window at the top of the display.
Press the QUIT key to finish.
Single, large data field
Default, medium fields
Split, small fields
Distance and
Bearing
Map Cursor
Full screen map shown
(with BlueChart data)
Cursor
Coordinates
If receiving proper sonar data from other device, such as a GSD 20 Sounder Module)