Filter
Top Products
Proximity Alarm—You have entered the alarm
radius for the proximity waypoint indicated.
Proximity List Full—You have used all nine
proximity waypoints.
Proximity Overlaps Another Prox Wypt—
The alarm radius specified overlaps the area
specified for another proximity waypoint. (See
section 10 for more information on proximity
overlaps.)
RAM has Failed—The random access memory
has failed and the unit is not operable. Take
your unit to an authorized GARMIN service cen-
ter for repairs.
ROM has Failed—The unit’s permanent mem-
ory has failed and the unit is not operable. Take
your unit to an authorized GARMIN service cen-
ter for repairs.
Received Invalid Waypoint—A waypoint was
received during upload transfer that has an
invalid identifier.
Receiver has Failed—A failure in receiver
hardware has been detected. If this message per-
sists, do not use the unit and take it to an autho-
rized dealer for repair.
Route Already Exists—The route number you
are trying to copy to is already used.
Route Does Not Exist—The route number you
are trying to use or copy is not defined.
Route is Full—You have attempted to add
more than 30 waypoints to a route.
Route Memory is Full—You have attempted to
create more than 20 routes.
Route Waypoint was Deleted—A route way-
point entered does not exist in the database and
has been deleted from the route.
RTCM Input has Failed—DGPS data being
received has been lost. You are no longer receiv-
ing the beacon signal.
Searching the Sky—The GPSMAP 135
Sounder is searching the sky for almanac data.
Shallow Water Alarm—The depth is equal to
or less than the set alarm depth.
Sonar ASIC has Failed—The unit’s internal
monitoring system indicates a malfunction. Send
in for service as soon as possible.
Stored Data was Lost—All waypoints, routes
and almanac data has been lost due to internal
battery failure.
There is No RTCM Input—The beacon receiv-
er is not properly connected or baud rates do
not match.
Timer Has Expired—The countdown timer
has expired.
Track Memory is Full—The track memory is
full and no additional track plot will be recorded
until the track memory has been cleared or set to
wrap mode.
Transducer-Sounder Turned Off—The trans-
ducer signal is not reaching the unit because of a
loose connector, bad wiring, or transducer mal-
function.
Wypt Already Exists—The waypoint name
you’ve entered already exists in memory.
Waypoint Memory is Full—You have used all
250 waypoints in the GPSMAP 135 Sounder sys-
tem.
89
SECTION
C
APPENDIX
Messages
GPS 135 Rev C 8/4/98 4:20 PM Page 89