Filter
Top Products
84
To flush mount the GPSMAP 135 Sounder:
1. Cut a 4.15” W x 4.67” H (105.4 x 118.6mm) hole in panel.
2. Place GPSMAP 135 Sounder into hole from the front until its flange rests against
the mounting surface.
3. From the back side of the panel, loosely attach the bracket so that the slot in the ratchet
area points away from the mounting panel.
4. Rotate the bracket downward until the panel is pinched tightly between the unit’s flange
and bracket lobe.
5. Tighten knobs and connect the power/data and antenna cables.
Transducer Installation
For installation, please refer to the booklet included with the transducer unit.
SECTION
A
APPENDIX
Installation
WARNING!
The temperature range for the GPSMAP 135
Sounder is -4 to +158ºF (-20 to 70ºC). Extended
exposure to temperatures exceeding this range (in
storage or operating conditions) may cause failure of
the LCD screen. This type of failure and related con-
sequences are NOT covered by the manufacturer’s
limited warranty.
GPS 135 Rev C 8/4/98 4:19 PM Page 84