Filter
Top Products
70 GPSMAP 400/500 Series Owner’s Manual
Appendix
—shows the MMSI or name
associated with an MMSI.
—internal problem with the unit. Contact your
dealer or Garmin Product Support to have the unit serviced.
—the Deep Water Alarm depth has been
reached.
—the MMSI
number is already in the DSC directory. Use a different number.
—the DSC
directory has reached the maximum of 100 contacts. Delete
unneeded contacts to add new ones.
—a DSC distress call has been received. Take
appropriate action.
—the target water
temperature is 2°F (1.1°C) above or below the temperature specied
by the Water Temperature Alarm. These messages appear when you
enter or leave that zone.
—the boat is approaching a safe region as
dened by your conguration settings.
—the boat is approaching an unsafe region
as dened by your conguration settings.
—a beep sounds (if enabled) when a sh is detected.
This alarm does not show a message banner.
—enter a valid MMSI.
—the unit has lost satellite signals. Check
antenna connections or try moving to a location with a clear view of
the sky.
—you must enter an
appropriate Keel Offset for the transducer (page 55).
attempted
to transfer user data from an SD card that does not contain the
specied type of data. Make sure there is data to transfer on the SD
card.
—you are off course the distance set in the “Off
Course” alarm.
—you entered a route name that already exists
in memory. Modify the route name or delete the previous route
name.
—you attempted to add more than 250 points to a
route. Reduce the number of points or create a second route.
—an uploaded route from another device has more
than 250 waypoints and was truncated to t.